Sargent and Greenleaf 6120 Instruções de Operação descarregar pdf (Página 14)

Operating Instructions

Model 6123—Motorized Electronic Combination Lock

The Sargent & Greenleaf Model 6123 combines ease of

operation with security and flexibility. Its advanced electronic

circuit design makes it easy to open and easy to change codes.

Follow these instructions carefully to get the best

possible use from your lock.

introduction

• The Sargent & Greenleaf Model 6123 Motorized Electronic

Combination Lock is shipped from the factory in single user

mode with a factory master code only. It is 1 2 3 4 5 6 #.

This code is used to open the lock and set or change all of

its codes. If the safe maker or your dealer sets a new master

code, he will advise you of the change. You should set the

lock to your own, unique master code immediately.

• The Model 6123 will always open on the master code. At your

discretion, it can also be set to accept a supervisor code,

up to five different user codes, and a time delay override

code. The master code holder is responsible for maintaining

the number of active users programmed into each lock. The

supervisor code holder can also create, change, and delete

user codes. The master code is designated as code #1. The

supervisor code (if set) is designated as code #2. The user

codes (if set) are designated by user I.D. number 3, 4, 5, 6,

and 7. The time delay override code (if set) is designated as

code #9.

• Each time a button is pressed, the lock acknowledges it by

sounding a “chirp,” and the LED on the keypad will light

momentarily as the “chirp” sounds.

• All codes must contain six digits or six letters. Any digit or

letter can be used as many times as you wish. For instance,

the following codes (while not recommended) will operate the

lock: 5 5 5 5 5 5 # OR J J J J J J #

• All codes end with #. This signals the lock that you have

finished entering all digits of the code.

• If you pause more than 10 seconds between button presses

when entering a code, the lock will assume you do not want

to continue, and it will reset itself to the original code. To

open the lock, begin the code entry sequence again from the

first step.

• If you realize you have pressed an incorrect button when

entering a code, press

or simply pause ten seconds or

more, then begin entering your code again.

• If four incorrect codes are entered in a row, the Model 6123

will shut down for a period of as long as fifteen minutes.*

This is a security feature. Pressing any button anytime during

the lockout period will reset the timer to its maximum penalty

time. Do not touch any keypad buttons for a period of fifteen

minutes, then enter any valid code(s) to open the lock.

The lock can also go into the lockout period during

programming if it interprets an incorrect programming

sequence as four or more incorrect code entries. If the lock

emits a long error tone (brap) during repeated programming

attempts, it may be in lockout mode. Do not press any

buttons for fifteen minutes, then try again.

The 6123 is extremely versatile, and therefore somewhat

complex to program. These detailed programming

instructions are followed by a condensed, two-page quick

programming reference that is designed for anyone who is

already familiar with the lock’s various features.

* 6120 and 6123 locks produced before mid 1997 shut down for fifteen

minutes. 6120 and 6123 locks produced after this shut down

for five minutes.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comentários a estes Manuais

Sem comentários

Sargent and Greenleaf 6120 Instruções de Operação Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Teclados numéricos Sargent and Greenleaf 6120